Acombination antenna
receives normal broadcast
channels (VILE2-13 and UHF
14-69). Your connection is easy
since there is only one 75_z
(ohm) antenna jack on the
back of your TV - and that's
where the antenna goes.
_lf your antenna has a
round connector (75_),
then you're ready to connect it
to the TV.
If your antenna has fiat
twin-lead wire (300_), you
first need to attach the antenna
wires to the screws on a 300
to 75&Qadaptor.
_Push the round end of
the adaptor (or cable) onto
the ANT(enna) IN jack on
the back of the TV. If the
round end of the adaptor or
cable is threaded, screw it
down tight.
To set the g
TV to select only
the channel num-
bers in your area,
see Auto Install on
page 4.
Combination
VHFIUHF
Antenna
(Outdoor or
Indoor)
%
Wire
Round Cable
75_
300 to 75_)
Adaptor
Back of TV
_o_
have two separate
antennas. One antenna is
for VIlE channels (2-13) and
the other antenna is for UHF
channels (14-69).
For homes with separate
UHF/VHF antennas, you will
need an optional combiner
before you can connect the
antennas to the TV.
U]_HF Attach the separate
and VHF antennas to
the correct screws on the
comb net.
Outdoor UHF Antenna
(Twin-lead 300f))
Twin-lead
Wire
Outdoor VHF
Antenna
(Twin-lead 300£_)
Outdoor VHF
Antenna
(Round cable 75_)
75-300_Adaptor
<_ Push the round end of the 1
combiner onto the ANT(enna)
IN jack on the back of the TV.
U/VCombiner
_) Round
End
To order
any optional
accessory, contact
_our dealer, Or,
call 1-800-851-8885
and refer to the fol-
lowing part num-
bers to order.
UHFNHF
Combiner:
4835 466 97016
75-300_
Adaptor:
M61009
300-75_
Adaptor:
4835 218 27003
I AN_IN
Back of TV
#
-2-
To Next Page
Loading...
Need help?
General