14
EN
1A23
INITIAL SETUP (SETUP WIZARD)
9 Select “AUTOSCAN” using [K / L],
then press [OK].
AUTOSCAN will rescan all channels.
This may take a while to complete.
EXIT
AUTOSCAN
The system is now scanning
12% Channel Found
EXIT
• STB starts receiving available digital channels
and stores them in the channel map.
• When the scanning is complete,
“AUTOSCAN COMPLETED” will be indicated.
• After autoscan is complete, press [CH / ] to
verify whether STB is receiving channels
properly.
The “SETUP WIZARD” is now complete.
To cancel during scanning:
Press [OK].
NOTE:
•
If autoscan is canceled, some channels not yet
scanned may not be received. We recommend
completing autoscan.
X6040UD_Book.indb 14X6040UD_Book.indb 14 10/22/2007 5:09:14 PM10/22/2007 5:09:14 PM
To Next Page
Loading...
Need help?
General
