18
EN
1A23
ADVANCED OPERATION
5 Select the channel number you want to
delete from the channel list on the right
using [K
/ L], then press [OK].
E.g., deleting channel 26.
ADD/DELETE
10
20
26
58
EXIT
CHANNEL
TIME
DETAIL
INITIAL
ADD
DELETE
26.1
ADD/DELETE
10
20
58
60
EXIT
CHANNEL
TIME
DETAIL
INITIAL
ADD
DELETE
56.1
[OK]
• The selected channel is now deleted.
To continue deleting:
Repeat step 5.
NOTE:
•
/
: Indicates that there are more channels
above or below.
6 Press [SETUP] to exit “SETUP” menu.
Adjusting Antenna
You can verify the signal strength of each channel to
get a clearer picture.
1 Select a channel to adjust using the
number buttons or [CH / ].
2 Press
[SETUP] to display “SETUP”
menu.
3 Select “CHANNEL” using [K
/ L], then
press [OK].
4 Select “ANTENNA” using [K
/ L], then
press [OK].
CHANNEL
EXIT
CHANNEL
TIME
DETAIL
INITIAL
ADD/DELETE
ANTENNA
AUTOSCAN
• STB starts receiving the signal for the channel.
5 Adjust the antenna’s direction to get
the best reception.
• A status bar stretches to the right according to the
signal strength.
• The value will be indicated on the left of the
status bar so that you can adjust the antenna.
WEAK
STRONG
BACK
NOW
10
PEAK
50
ANTENNA
EXIT
CHANNEL
TIME
DETAIL
INITIAL
10.1
To adjust other channels:
Select the channel with
[CH / ]
, then adjust it.
To cancel during adjustment:
Press
[SETUP]
or
[OK]
.
6 Press [SETUP] to exit “SETUP” menu.
Receiving Channels (Autoscan)
STB can get available digital channels automatically.
Autoscan receives available digital channels and
stores them in a channel map. These channels can
then be selected using [CH / ].
CAUTION:
•
If autoscan is skipped, digital channels may not be
received correctly.
1 Press [SETUP] to display “SETUP”
menu.
2 Select “CHANNEL” using [K
/ L], then
press [OK].
3 Select “AUTOSCAN” using [K
/ L], then
press [OK].
CHANNEL
EXIT
CHANNEL
TIME
DETAIL
INITIAL
ADD/DELETE
ANTENNA
AUTOSCAN
X6040UD_Book.indb 18X6040UD_Book.indb 18 10/22/2007 5:09:17 PM10/22/2007 5:09:17 PM
To Next Page
Loading...
Need help?
General
