2-○
10
MODE
When pressing “MODE” button 5 times you may move to “ dAtA Set”
showing on the display. Then press MODE button again in order to move
to the following mode set-up. You can select each of levels like
speed/density/batch/beep on&off/stacker alarm by 9 and 0 button.
-. Ed-A : Density Levels
-. SS-A : Short & Chain note detection
-. bt-A : Batch number preset
-. bu-A : Beep on/off
-. St-A : Stacker Alarm
-. SPd : Speed Change
(30UD, 30UMD, 30SUMI & 30SU Only)
L-1 : 1,200 notes per minute
L-2 : 1,300 notes per minute
L-3 : 1,500 notes per minute
L-4 : 1,800 notes per minute
-. At-n : Auto / Manual Start(For 30UMD & 30SUMIOnly )
- HP-t : Hopper Alarm
- bL-A : Length & Chain note detection
(For 310S & 310SU Only)
In order to exit the
MODE function press RESET/START button.
For the details of the MODE functions you may refer to the SERVICE
MANUAL- SERVICE MODE . It shows the way as to how to change each
of set-up.
To Next Page
Loading...
