Magner 915 - Control Panel Functions

Magner 915 User Manual
3
Keys
Functions
“START/STOP”
Press this key to START/STOP the machine to count. When it
starts, the red indicator n the upper side will be lighted on.
“ADD”
Press this key to turn ON/OFF Accumulative counting mode.
When the function is on, the red indicator on the upper side will be
lighted on.
“BAT”
Press this key to turn ON/OFF batch counting mode. When the
function is on, there will be a sign of “P” to indicate. The previous
set batch number will be recorded and displayed again when you
turn on the function again.
“CLR”
To clear data. Press this key one time will clear the present
counted number; Press this key and BAT together at the same
time will clear the batch number.
“MR”
When ADD function is off, hold on pressing MR key will get the
total counted number after the machine is turned on; When ADD
function is on, hold on pressing MR key will get the previous total
counted number before the machine is turned on.
“+1000”
To increase batch number by 1000 at one time. The number will
be changed from 0 to 9000.
“+100”
To increase batch number by 100 at one time. The number will be
changed from 0 to 900.
“+10”
To increase batch number by 10 at one time. The number will be
changed from 0 to 90.
“+1”
To increase batch number by 1 at one time. The number will be
changed from 0 to 9.