Magner PRB - Messages in Course of Operation

MESSAGES IN COURSE OF OPERATION
Table 2. Error messages
Error
Messages
P.O.S.T.
ERROR
An error occurred during self-
testing of the counter (at its
switching on), the sensors are
covered by foreign object.
An error occurred during self-
testing of the counter (before
the start of a count), the
sensors are covered by
foreign object.
Switch off the machine.
Remove banknotes and/or
foreign objects from the
hopper, the stacker, the reject
pocket, and the path. Then
switch on again. If the error is
reappeared, call a technician.
Switch off the machine.
Remove banknotes and/or
foreign objects from the
hopper, the stacker, the reject
pocket, and the path. Then
switch on again. If the error is
reappeared, call a technician.
Reason Teller's actions
S.M.A.R.T.
ERROR
The banknotes are jammed. A
foreign object in the path
blocks the gear and causes
the overcurrent.
Switch off the machine. Open
the path, and remove the
jammed banknotes, the
foreign objects.
Overcurrent
The banknotes get jammed.
Foreign object in the path
blocks the switch between the
hopper and the reject pocket.
Open the path, remove the
jammed banknotes, foreign
objects from switch area.
Switch
error
The calibration error is
occurred during the self-test.
Switch off the machine. Open
the path and remove the
banknotes, the foreign objects
blocking CIS (see item 3,
Figure 5, Figure 6). Then
switch on again. If the error is
reappeared, call a technician.
Calibration
error
37
36
Table 2
Error
Messages
Note's jam,
clean the
path!
A banknote is jammed in the
path during counting.
More banknotes than required
were placed into the stacker in
the batch mode
Remove banknotes from the
hopper, open the path and
remove the banknotes from
there.
The red circles on the picture
are marked the places of
possible jams.
Remove the banknotes from
the stacker, and recount the
batch.
Reason Teller's actions
Batch
error
Counting error Clean the stacker, and
recount the banknotes.
Counting
error please,
re-count
Incorrect feeding of the
banknotes.
Remove banknotes from the
hopper, open the path and
remove the banknotes from
there.
Adjust the hopper's guides
according to the length of the
longest banknote in the batch,
level the batch edges
(separate banknotes shall not
to protrude from the batch),
and place them in the hopper
avoiding their skew.
Feed
error
Table 3. Info messages
Path's open
The path is open, the upper
part is open.
Close the path.
Messages
Path's closed
Path cleaning
After the path is closed, the
self cleaning of the path is in
progress.
Wait till cleaning of the path is
over.
Reason Teller's actions
MAGNER PRB VALUE COUNTERMAGNER PRB VALUE COUNTER