Magnetek 2001-G+M - Page 5

G+ Mini Transition Guide September 2008
Page 5 of 24
Magnetek, Inc.
Product Transition Guide
G+ Mini Rev:
Options,
Others
Option
Cards
< Is an option card installed? >
• Check if any option card is installed.
– If an option card is installed, get the equivalent option card for the G+ Mini.
– Never attempt to apply P3 Series 2 option cards to the G+ Mini unit.
– The option card on the G+ Mini may have another connector on the P3 Series 2. Make
sure that the connectors fit into the new option card before using it.
Others
< Is a braking resistor installed?
>
• Check if a braking resistor is installed on the current drive.
– Inspect the braking resistor for physical damage or wear before connecting it to the
new drive.
– Connect the braking resistor to the equivalent terminals on the new unit.
– The terminals might have a different location in the new drive; check to ensure that
existing wiring is long enough to reach the new terminal location.
< Is a braking unit installed?
>
• Check if a braking unit is used in the current installation.
– Inspect the braking unit for physical damage or wear before connecting it to the new
drive.
– Connect the braking unit to the equivalent terminals on the new unit.
– The terminals might have a different location in the new drive; check to ensure that
existing wiring is long enough to reach the new terminal location.
< Is an AC reactor or DC choke installed?
>
• Check if an AC reactor or DC choke is used in the current installation.
– Inspect the reactor or choke for physical damage or wear before connecting it to the
new drive.
– Make sure that the reactor or choke data are appropriate for the replacement drive.
– The terminals might have a different location in the new drive; check to ensure that
existing wiring is long enough to reach the new terminal location.
• Refer to the instruction manual for questions about installation, parameter settings or detailed parameter/function descriptions.
Item Checkpoints Checked?