Need help?Do you have a question about the Magnetek 4 Series and is the answer not in the manual?
Defines the safety message conventions used throughout the manual for hazard communication.
Describes automatic collection of run, fault, and alarm events with associated measurements.
Describes the logging of drive monitor information in a graphical format over time.
Describes the storage, retrieval, and use of drive settings and configurations.
Logs run duration, peak/average values, and links to associated alarms or faults.
Logs specific faults, applies filters, and records any linked run events.
Logs alarms, drive configuration details, and any linked run events.
Stores up to 10 parameter sets from a connected drive into the DLS4 unit.
Writes stored parameter sets from the DLS4 unit back to a compatible drive.
Lists the specific drive series, models, and types supported by the DataLogger Series 4.
Details the physical connection methods for the IMPULSE•G+/VG+ Series 4 drive.
Details the connection method using an RJ45 cable for IMPULSE•G+/VG+ Series 3.
Explains the menu navigation and key functions for Series 4 and DC drives.
Logs detailed run, fault, and alarm events with associated measurements and data.
Displays the total count of logged Run, Fault, and Alarm events stored in memory.
Provides an option to clear all logged history data (Run, Fault, Alarm) from the DLS4.
Allows filtering specific faults or alarms to exclude them from the history logs.
Sets the time criteria for determining the end of a run event for logging purposes.
Allows selection of specific monitors to be logged in the trending data.
Enables logging of trending data even when the drive is not actively running.
Provides an option to delete all trending data logs stored on the DLS4.
Stores parameter sets from a drive into DLS4 slots for backup and later use.
Writes stored parameter sets from DLS4 slots back to a compatible drive.
Clears individual parameter data slots (1 through 10) on the DLS4.
Assigns custom names to stored parameter sets for easier identification.
Adjusts the DLS4's internal clock and daylight saving time settings.
Displays the current firmware version of the DataLogger Series 4 unit.
Provides low-level status and troubleshooting information for DLS4 hardware components.
Configures the communication baud rate for data transfer with connected drives.
Tests DLS4 hardware components, display, LEDs, and keypad functionality.
Provides instructions for replacing the internal battery when the unit is not powered.
Outlines the process for updating the DLS4 firmware using the IMPULSE•Link 5 software.
To Next Page
General
