Replace vacuum pump filter!
Continue?
This message appears after starting the station, once it has reached the scheduled
maintenance interval. After replacing the component, reset the counter.
See 11.4.2 Resetting counters
Pressure sensor auto-calibration?
This message appears after starting the station. Select ENTER to allow the station to perform
auto-calibration of the pressure sensor.
Start operation?
Select ENTER to start the planned process or cycle.
Process finished!
Select ENTER to go to standby mode.
A new database
version is
available.
This message appears one year after database memory card activation.
Select ENTER
Please contact
the distributor.
Select ENTER to go to standby mode. See Replacing memory card. Replacing the memory
card into a card with a new database will disable the message automatically.
Printer
does not work!
Printer is not available (printer led flashes). Possible reasons include open printer cover or
no paper.
Select ENTER to continue with the next phase. Select STOP/RETURN to return to standby
mode.
If there are no paper in the printer, lift the printer cover to secure the head.
Use only paper available in Magneti Marelli Aftermarket offer. This message is
accompanied with a warning sound.
Select ENTER to exit.
ļ The message appears only
when optional printer is
installed
To Next Page
Loading...