> Alfa Romeo <
Use UP-DOWN buttons to select the brand or go to user vehicles.
Confirm by pressing ENTER.
After selecting the brand you need to repeat all successive operations to confirm system
filling parameters.
Refrigerant qty g: XXXXX
Vacuum: XX:XX
Vacuum generation time is calculated based on the refrigerant quantity specified.
Use UP-DOWN buttons to select the oil/UV injection program.
See 9.5 Programming oil/UV injection phase.
Confirm by pressing ENTER to start the automatic program with manual oil/UV injection.
>User vehicles<
Alfa Romeo
Use UP-DOWN buttons to select the user’s vehicle.
Confirm by pressing ENTER.
See 9.2.1 User vehicles.
8.4 User program
When entering the program selection mode (see 9 PROGRAMS) the following menu
appears:
Auto Progr. ■
User progr. □
Select using UP-DOWN buttons. Confirm by pressing ENTER.
Recycle? Yes
No
Select using UP-DOWN buttons. Confirm by pressing ENTER.
If NO option is selected, the station will suggest going into vacuum phase.
If YES option is selected, the following message is displayed:
Control of min.
pressure growth
A 1-minute pressure growth test will be proposed before concluding the refrigerant recovery
phase.
Use UP-DOWN buttons to select the desired value. Confirm by pressing ENTER.
Vacuum? Yes
No
Select using UP-DOWN buttons. Confirm by pressing ENTER.
If NO option is selected, the station will suggest going into filling phase.
If YES option is selected, the following message is displayed:
To Next Page
Loading...