8
Safety Notifications
Electrical lockout points.
Disconnect electric before opening or servicing. Use
Power Lockout Tagout.
Pneumatic lockout points.
Disconnect compressed air supply before opening or
servicing. Use Air Lockout Tagout.
CAUTION - Always wear safety glasses when using this
equipment.
SAFETY INTERLOCK SWITCH
The ACCESS DOOR is equipped with a safety interlock
switch that prevents the mix motor from running and the slide
valves from opening. DO NOT d
HOPPER FINGER GUARDS
Finger Guards are fitted into each Material Hopper compartment.
DO NOT reach through these Guards.
DO NOT use fingers to clear an obstruction below these guards.
DO NOT remove these Guards.
HAZARD - AUTOMATIC STARTUP
WARNING - Blender may start automatically without warning.
Maximum continuous noise level - The highest continuous Noise levels
recorded for this equipment was measured at 71.4 db.
To Next Page
Loading...
Need help?
General