To Next PageTo Next PageWhat causes reference sensor or LED defective on MAHA Test Equipment?
If your MAHA Test Equipment shows that the reference sensor or LED is defective, first check if the transmitter and receiver are properly installed and screwed in. Also, check if the glasses are soiled and clean them. If the problem persists, turn the master switch off, wait 10 seconds, and then turn it back on. If there's still no improvement, contact service.
How to solve check filter pump defective error on MAHA Test Equipment?
If your MAHA Test Equipment displays a 'Check filter; pump defective' message, first ensure that the F1 filters are mounted correctly and that the cover of the water extractor is not open. Then, turn the master switch off, wait 10 seconds, and then turn it back on. If the problem continues, contact service.
What to do if error occurs during leaktightness test on MAHA Test Equipment?
If your MAHA Test Equipment shows an error during the leaktightness test, check the following: Ensure the probe seal tubing is correctly pushed onto the probe tip, the sample line is inserted into the unit, the two F1 filters are mounted correctly, the transmitter and receiver of the opacimeter are mounted correctly, and the cover of the water extractor is screwed on correctly. If the problem persists after checking these, turn the master switch off, wait 10 seconds, and then turn it back on. If there's still no improvement, contact service.
How to fix LED too dim on MAHA Test Equipment?
If the LED on your MAHA Test Equipment is too dim, first ensure that the transmitter and receiver are properly installed and screwed in. If they are, check if the glasses are soiled and clean them. If the issue persists, turn the master switch off, wait 10 seconds, and then turn it back on. If the LED remains dim, contact service.
How to fix filter blocked error on MAHA Test Equipment?
If your MAHA Test Equipment displays a 'Filter blocked!' message, change both F1 filters. Then, turn the master switch off, wait 10 seconds, and turn it back on. If the problem persists, contact service.
What causes opacimeter sensor defective in MAHA Test Equipment?
If your MAHA Test Equipment's opacimeter sensor is defective, start by checking if the transmitter and receiver are correctly installed and screwed in. Also, verify that the filter glass holder is inserted correctly and that the servicing hatches are closed during start-up. Ensure that the glasses are clean. If none of these steps resolve the issue, turn the master switch off, wait 10 seconds, and then turn it back on. If the problem continues, contact service.
What to do if antenna symbol flashes and WiFi is not working on MAHA Test Equipment?
If the antennae symbol is flashing on your MAHA Test Equipment and the WiFi is not functioning, it might be due to a too-fast unit restart. Try turning the master switch off, waiting 10 seconds, and then turning it back on. If this doesn't solve the problem, use a LAN cable and the “MET Service Tool” program to transfer the WiFi configuration to the unit. If the issue persists, contact service.
General| Brand | MAHA |
|---|---|
| Model | MET Series |
| Category | Test Equipment |
| Language | English |
