H-11
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
6. AIR BLEEDING THE SYSTEM
1. Maintain the oil level in transmission housing by
means of dipstick. Be ready to add oil when the
engine is started.
NOTE: This oil will be circulated only from the power
pump to and through part of the HSU control
valve and to the power steering pump. When
more oil can be added and oil is clear proceed
as follows:
3. Turn the steering wheel alternately left and right,
approx. 10 times avoiding, however that wheel
contact their front axle stops. Turn steering wheel
twice to each side.
4. After venting it is recommended to jack up the
front axle, especially if steering cylinder is
removed.
Do not operate vehicle until air is
bleed out.
5. Maintain recommended oil level in reservoir and
assemble reservoir cap.
7. TIPS FOR MAINTAINING THE HYDROSTATIC
STEERING SYSTEM
• Top up fluid level in reservoir (transmission
housing) if necessary.
• Maintain correct inflation pressure in front tire.
• Always use a puller to remove the steering wheel.
Do not use a hammer, torch, or crow bar.
• Investigate and correct immediately any play,
raffle, shimmy, or other unusual occurrence in
the steering system.
• Do not attempt to weld any broken steering
component. Replace the component with original
equipment only.
• Do not cold straighten, hot straighten, or bend
any steering part.
• Prevent dirt or other foreign matter from entering
the hydraulic system. Clean off around filler caps
before checking oil level. Investigate and correct
any external leak in the steering system, no matter
how minor the leak.
• Clean or replace the filter as per the routine
service schedule.
Steering
To Next Page
Loading...
Need help?
General
