MAHLE MCX-2 - Completing the Job

13
COMPLETING THE JOB
COMPLETING THE JOBCOMPLETING THE JOB
COMPLETING THE JOB
All used coolant in the vehicle cooling system has now been replaced with new coolant. The
following steps will complete the job.
1. Turn both valves on front of MCX-2F to EXCHANGE.
2. Close the valves on the Step Adapters.
3. Disconnect the black and green hoses from the Step Adapters.
4. Install Wand on black hose. Close the valve.
5. Remove the cap from the radiator.
6. Turn control valve to LOWER RADIATOR & OVERFLOW.
7. Press top of LOWER RADIATOR & OVERFLOW selector switch to turn on pump.
8. Use the Wand to lower the level of coolant in the radiator to a level just below the upper hose
where the Step Adapter is attached. Open valve on Wand as required.
Continued on next page . . .
Continued on next page . . .Continued on next page . . .
Continued on next page . . .
OFF
EXCHANGE C OOLANT OR
FILL RADIATOR & OVERFLO W
Green Hose
OFF
SYSTEM VACUUM
EMPTY WAST E TANK
TEST
FILL RADIATOR
& OVERFLO W
EMPTY WAST E TANK
LOWER RADIAT OR
& OVERFLO W
SYSTEM PRES SURE
EXCHANGE C OOLANT
OFF
& OVERFLOW
LOWER RADIATOR
EMPTY W ASTE TANK
Overflow
& OVER
FLOW
LOWER RADIAT OR
Wand
Radiator
Black Hose
Hose
Radiator
EMPTY W ASTE TANK
OFF
FILL RADIATOR & OVERFLOW
EXCHANGE COOLANT OR
SYSTEM VACUUM
OFF
EXCHANGE COOLANT
SYSTEM PRESSURE
& OVERFLOW
FILL RADIATOR
TEST
Block
Pump
Water
Engine
LOWER RADIATOR
& OVERFLOW
OFF
Heater
Core