To Next PageTo Next Page
Need help?Do you have a question about the Main Eco Compact Heat 30 and is the answer not in the manual?
Outlines crucial safety precautions, including gas leak procedures and child safety.
Provides essential recommendations for installation, repair, and maintenance safety.
Details safety advice specifically for handling and lifting the boiler unit.
Offers guidance on safe manual handling techniques and the use of PPE to prevent injury.
Specifies regulatory requirements and standards that must be followed during installation.
Details essential requirements for gas and electrical supply connections to the boiler.
Outlines standards and considerations for connecting the gas supply to the boiler.
Covers electrical supply voltage, fusing, and isolation requirements for safe installation.
Details the correct installation of the condensate discharge pipe to prevent blockages and lock-outs.
Covers the installation of the flue system, including telescopic sections and elbow fitting.
Step-by-step guide for fitting the top flue assembly to the boiler.
Details connecting external control devices and wiring requirements for the boiler.
Explains how to connect the mains supply and internal wiring of the appliance.
Shows connection diagrams for system controls like timers and thermostats.
General guidance and references for commissioning the boiler according to standards.
Lists pre-commissioning checks for electrical safety and system integrity.
Specifies essential electrical system checks using a meter before startup.
General checks for installation integrity, flue seals, and gas/water joints.
Outlines the initial steps to start and operate the boiler for the first time.
Details how to set the boiler for optimal combustion performance.
Explains how to activate 'Chimney Sweep' Mode for combustion checks.
A flowchart guiding the combustion analysis and adjustment process.
Procedures for checking gas inlet pressure and gas rate for proper system configuration.
Verifies the gas pressure at the boiler inlet against specified standards.
Final steps, handover procedures, and user instructions after commissioning.
Emphasizes the need for annual servicing by a competent person and checks during maintenance.
Step-by-step guide for visual checks, cleaning, and replacement of common parts.
Detailed instructions for checking and adjusting CO2 levels for optimal combustion.
Explains how error codes are displayed and lists conditions with remedial actions.
Describes lockout conditions, their causes, and how to reset the boiler.
General
