6
EN
Instructions Guide
Wall Mounting
Safety
1. Installation must be carried out by qualied personnel only. Incorrect
assembly can result in severe personal injury and property damage. If
you are going to install this Soundbar yourself, you must be aware of
electrical wiring and plimbling that may be buried inside the wall. It is
the installer’s responsibility to verify that the wall will safely support the
total load of the Soundbar.
2. Additional tools (not included) are required for the installation.
3. Do not over-tighten screws.
4. Keep this manual for future reference.
5. It is advisable to use an electric stud nder to check the wall type
before drilling and mounting.
Tools & xings required:
1. Drill tted with masonry drill
part
2. Screwdriver
3. Pencil
4. Ruler
5. Spirit level
Place the soundbar in the desired position and use a spirit level to check
that the soundbar is level.
Make a light pencil mark on the wall at both xing brackets. Drill 4
parallel holes accordingly. The distance between 2 sets of holes are
recommended to be 140mm as shown below.
To Next Page
Loading...
