7
Press the ‘Standby/Mode’ button (Ref.). On rst use DAB Radio
will automatically start scanning all stations and save them.
To auto scan (if the unit hasn’t automatically done so, or shows
no signal) press and hold the ‘Info/Menu’ button (Ref.) and
when the display shows “FULL SCAN”, press the ‘Enter’ button
(Ref.).
The unit will start scanning up the frequency band and store all
stations that have a good signal. Please note: if you are not in a
good DAB signal area then you won’t get a strong signal, if any.
The radio will automatically save all those stations that have a
strong signal. After searching has nished it will automatically
play the rst station stored.
To listen to any of the stations that have been stored, use the
‘Next’ (Ref.) and ‘Prev’ (Ref.) buttons to navigate through the
stations.
The radio will display station information when you press the
‘Info/Menu’ button (Ref.). Press multiple times to view all
information available (See page 11).
When you turn the radio on again after switching it o, it will
automatically tune to the same station (DAB or FM) that was last
selected.
Instrucons Guide
DAB/DAB+ Radio Mode
To Next Page
Loading...
Need help?
General
