5
Please note all (Ref.) refer to the Controls and Functions
mapping guide on Page 1.
Switch the ‘ON/OFF’(Ref.) button on top of the system to ‘ON’.
“Welcome to Digital Radio” will show on the display, followed by
the clock time.
Ensure the system has been charged, the battery life will show
on the display when you turn on. If the battery icon shows all of
the bars illuminated then the system is fully charged.
To charge the device, use the USB cable provided and plug
it into a computer or a plug (not supplied) that accepts USB
connectors.
Press the ‘Standby/Mode’ button to turn on the unit (Ref.). The
system should go straight to DAB Radio and automatically start
scanning for stations. The display will show “Searching” and can
take a few minutes to scan.
Press the ‘Standby/Mode’ button (Ref.) to switch to FM or again
to switch back to DAB.
Ensure that the earphones are connected into the top of the
system correctly (Ref.) as they are also the antenna of your
radio. Without them, no DAB/FM signal will be received.
Use the Vol -/Vol + buttons to control the volume of the radio.
Instrucons Guide
Basic Operation
To Next Page
Loading...
Need help?
General
