MAJORITY D80 - Setting Up Your Majority D80 Speakers; Connecting and Powering the Unit; Remote Control Battery Installation

SETTING UP YOUR MAJORITY D80 SPE AK ERS
EN
7
Connecting and powering the unit
Using the power cord provided, plug one end into the back of the primary speaker
and plug the other end into a mains socket. Switch the unit on at the back of the
primary speaker .
Connect the two speakers together via the speaker connector cable. To do this, plug the
left speaker connector cable plug into the right (primary) speaker connector.
Switch on your Majority D80 Speakers
Press the ฀ button to switch on the speakers. Press the ฀ button to switch the
speakers off.
Remote Power
Remove the battery cover of the remote control. Insert 2 x AAA batteries (excluded).
Replace battery cover.
Note: when using the remote control, ensure that you are pointing at the remote sensor
otherwise the unit may not respond to key presses.