How to fix MAJORITY FITZWILLIAM Receiver connecting to network problems?
If you're having trouble connecting your MAJORITY Receiver to the network, ensure the system is properly connected wirelessly or via wire. Verify that the network signal is strong and that there are no firewalls on your WiFi network preventing the connection.
Why is my Bluetooth not connecting to my MAJORITY Receiver?
If your Bluetooth device isn't connecting to your MAJORITY Receiver, first, make sure the radio is in Bluetooth mode and that Bluetooth is enabled on your device. Then, select the Bluetooth device ‘Majority Fitzwilliam’. If audio doesn't play, disconnect and reconnect the device in your Bluetooth settings.
What to do if there is no sound from my MAJORITY FITZWILLIAM?
If there's no sound from your MAJORITY Receiver, ensure it's connected to an external speaker via an output port. Check that the correct MODE is selected. If connected via Bluetooth or AUX, increase the volume on your device.
General| Radio | DAB/DAB+/FM |
|---|---|
| Display | LCD |
| Remote Control | Yes |
| Presets | 20 |
| Alarm Clock | Yes |
| Sleep Timer | Yes |
| Headphone Jack | 3.5mm |
| Frequency Response | 20Hz - 20kHz |
| Power Output | 2 x 15W |
| Connectivity | Bluetooth, AUX, USB |
| Power Source | Mains |
| Bluetooth Range | 10m |
Details the controls on the front panel of the radio unit.
Describes the various input and output ports on the rear of the unit.
Explains the functions of buttons on the remote control for operating the radio.
Explains how to navigate menus and adjust settings on the unit.
Guide to initial setup, power-on, and basic configuration steps.
Step-by-step instructions for connecting the radio to a WiFi network.
How to access and use the Internet Radio feature, including station lists.
How to tune into DAB/DAB+ stations, scan, and preset them.
Instructions for tuning into FM stations, scanning, and presetting.
Guide to configuring system settings like Equaliser, Network, and Time/Date.
To Next Page
