29
EN
Setting the Alarm
1. Press TIMER button on the remote control, the display shows “Alarm (1 or 2): O [hh:mm]”.
2. Press
12
w
/
s
3
buttons to select the Alarm number (1 or 2) and then press the SELECT button to
start the setting of the following parameters.
Press
12
w
/
s
3
buttons to select then press the SELECT button to conrm
Enable O/ Daily/ Once/ Weekends/ Weekdays
Time (Alarm On time)
Mode Buzz/ Internet radio/ DAB/ FM /CD /USB
Preset Last Listened/ (Preset station)
Volume 0-32
Save Save and conrm the alarm setting
3. Finally, select "Save" and press the SELECT button to save the alarm setting. The display will show
Alarm Saved. When the alarm is set, the alarm icon will apear on the display.
4. To turn o the alarm when it sounds, press the
q
/VOLUME dial on unit or
q
button on remote
control, or ALARM button on remote control
Cancelling the Alarm
1. Press TIMER button on the remote control, the display shows “Alarm (1 or 2): On [hh:mm]”.
2. Press the
12
w
/
s
3
buttons to select the Alarm number (1 or 2) and then press SELECT button to
start the setting of the timer.
3. Press the
12
w
/
s
3
buttons to select “Enable” then press the SELECT button to conrm.
4. Press the
12
w
/
s
3
buttons to select “O” then press the SELECT button to conrm.
5. Finally, select "Save" and press the SELECT button to save the setting.
6. Alternatively, during Standby mode, press the TIMER button on remote control repeatedly can
turn the saved Alarm 1/2 on/o sequentially.
If no button is pressed within approx. 30 seconds, the unit exits timer setting mode
automatically.
Instructions Guide
To Next Page
Loading...
Need help?
General
