Make Mendel RapidBot Mega - Page 8

MAKE MENDEL Page 8
Acrylic Base Plate Fitting
(2)
Z- Opto (1)
2
M4 x 20 Socket
Cap (14)
Acrylic Support (12)
Acrylic Base Plate (2)
3
M4x25 Counter
Sink (2)
294 mm Smooth Rod
Cap (6)
4
M4 X 25 Socket cap
(19)
300 mm Smooth Rod(6)
Acrylic Support(13)
5
M4 X 40 Socket cap
(2)
Belt Adjustment X,Y (2)
6
M4 X 20 Mudguard
Washer (4)
Belt Adjustment (4)
7
M4 Washer (80)
Main Structure Panel
(50)
624 Bearing Belt (11)
Extruder Motor Support
Plate (4)
Smooth Rod Cap (14)
Other Parts
1
624 Bearing (7)
X, Y Adjusting Belt (7)
2
623 Bearing (1)
Extruder Idler Holder
Part (1)
3
608 Bearing (2)
PLA Spool Holder (2)
4
M8 Nuts (12)
PLA Spool Holder
(8)
5
M6 Brass Nut (2)
Extruder (2)
6
Flange Nut (2)
Y Plate Threaded Rod
7
Flange Bearing (2)
Y Plate Smooth Rod
8
Smooth Rod Cap (4)
Smooth Rod Cap (4)
[Top Plate
Bottom Plate]
Note : How to Increase the build dimensions for Mega in Pronterface
1) Start ProntrFace
2) Go to Settings->Options->Set Build_dimensions to “750x250x165+0+0+0”.
3) Press Ok, and then close and restart the Prontrface
4) It will show you updated PrintBed grid.