Makita 4329 - Switch action; Speed adjusting dial; ASSEMBLY; Installing or removing saw blade

5 ENGLISH
Switch action
1
2
►1. Switch trigger 2. Lock button
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial (For models
4327/4327M/4328/4329)
1
►1.Speedadjustingdial
Thetoolspeedcanbeinnitelyadjustedbetween500
and3,100strokesperminutebyturningtheadjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 6; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Workpiece to be cut Number on adjusting dial
Wood 5 - 6
Mild steel 3 - 6
Stainless steel 3 - 4
Aluminum 3 - 6
Plastics 1 - 4
CAUTION:
• If the tool is operated continuously at low
speeds for a long time, the motor will get over-
loaded and heated up.
•
Thespeedadjustingdialcanbeturnedonlyasfar
as 6 and back to 1. Do not force it past 6 or 1, or
thespeedadjustingfunctionmaynolongerwork.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing saw blade
1
2
3
►1. Blade holder 2. Bolt 3. Hex wrench
CAUTION:
• Always clean out all chips or foreign matter
adhering to the blade and/or blade holder.
Failuretodosomaycauseinsufcienttighten-
ing of the blade, resulting in a serious personal
injury.
• Do not touch the blade or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
• Alwayssecurethebladermly.Insufcienttight-
ening of the blade may cause blade breakage or
seriouspersonalinjury.
• Use only B type blades. Using blades other than
Btypebladescausesinsufcienttighteningof
theblade,resultinginaseriouspersonalinjury.
(For models 4326/4327/4328/4329)
• Use only Makita type blades. Using blades other
thanMakitatypebladescausesinsufcient
tightening of the blade, resulting in a serious
personalinjury.(Formodels4326M/4327M)