Makita 4350T - Operation and Bevel Cutting; Bevel Cutting

7 ENGLISH
To remove the blade, open the tool opener to the posi-
tionshowninthegure.Pullthesawbladeouttoward
the base.
1
►1. Jig saw blade
NOTE:
• Occasionally lubricate the roller.
Hex wrench storage
1
2
►1. Base 2. Hex wrench
When not in use, the hex wrench can be conveniently
stored.
OPERATION
CAUTION:
• Holdthetoolrmlywithonehandonthemain
handle when performing the tool. If necessary,
the front part of the tool may be supported by
the other hand.
• Alwaysholdthebaseushwiththeworkpiece.
Failure to do so may cause blade breakage,
resultinginaseriousinjury.
1
2
►1. Cutting line 2. Base
Turn the tool on and wait until the blade attains full
speed.Thenrestthetoolbaseatontheworkpiece
and gently move the tool forward along the previously
marked cutting line. When cutting curves, advance the
tool very slowly.
Bevel cutting
CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the bevel slot in the base.
1
2
3
►1. Base 2. Bolt 3. Hex wrench