9 ENGLISH
You can drive nails repetitively by placing the contact
element with the trigger held.
To choose this mode, set the actuation mode selector
to the position.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Nails
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape,
causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
Maintenance of nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
With tool disconnected, make daily inspection to
assure free movement of the contact element and
trigger. Do not use tool if the contact element or
trigger sticks or binds.
CAUTION: Always release the trigger and
disconnect the hose before removing jammed
nails.
CAUTION: Do not use deformed nails or nail
strip. Failure to do so causes poor nail feeding.
Single sequential actuation
To Next Page
Loading...
Need help?
General
