To Next PageTo Next Page
Need help?Do you have a question about the Makita AN902 and is the answer not in the manual?
General| Operating Air Pressure | 70 - 120 psi |
|---|---|
| Magazine Capacity | 100 nails |
| Air Inlet | 1/4" NPT |
| Fastener Type | Round head nails |
| Hose Inner Diameter | 3/8" |
Details the components of the tool identified by numbers.
Provides technical data including model, air pressure, nail capacity, and dimensions.
Defines the tool's application in interior work like fixing floor joists or common rafters.
Emphasizes the importance of reading the manual before operating the tool.
Mandates wearing safety glasses to protect eyes from injury.
Recommends wearing hearing and head protection for safety.
Covers warnings about tool operation, environmental hazards, and proper handling to prevent accidents.
Guidance on choosing an air compressor based on pressure and output requirements.
Advice on selecting an air hose for optimal performance and efficiency.
Instructions for lubricating the tool with pneumatic tool oil.
Explains the tool's primary functions and how they work.
Explains how to adjust the nailing depth and manage air pressure settings.
Instructions for attaching the nose adapter to protect surfaces.
Steps for loading nails into the magazine and securing the coil.
Procedure for connecting the air hose to the tool.
Instructions for operating the tool in continuous nailing mode.
Instructions for operating the tool in sequential (intermittent) nailing mode.
Procedure for clearing a jammed nailer and handling nail coils.
Covers daily checks, inspection of contact element and trigger, and storage lubrication.
Details maintenance for the air supply system, including draining and lubrication.
Information on recommended accessories for the tool.
Details sound pressure and power levels, and uncertainty according to EN792.
Presents vibration emission values and uncertainty according to EN792.
Manufacturer's declaration of compliance with European directives and standards.
