10 ESPAÑOL
When the tool is not to be used for an extended period of
time, lubricate the tool using pneumatic tool oil and store
the tool in a safe place. Avoid exposure to direct sunlight
and/or humid or hot environment.
Maintenance of compressor, air set
and air hose
After operation, always drain the compressor tank and the
air filter. If moisture is allowed to enter the tool, it may
result in poor performance and possible tool failure.
Check regularly to see if there is sufficient pneumatic tool
oil in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
► 1. Oiler 2. Pneumatic tool oil
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles
which it may become dangerously caught on during
operation. Hoses must also be directed away from
sharp edges and areas which may lead to damage or
abrasion to the hose.
OPTIONAL
ACCESSORIES
CAUTION: These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details
regarding these accessories, ask your local Makita
Service Center.
• Nails
• Air hose
• Hex wrench
• Safety goggles
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
MAKITA LIMITED WARRANTY
Please refer to the annexed warranty sheet for the
most current warranty terms applicable to this
product. If annexed warranty sheet is not available,
refer to the
To Next Page
Loading...
Need help?
General
