What to do if cutting tool and motor cannot stop on Makita DCE090 Cutter: Remove the battery cartridge immediately?
If the cutting tool and motor of your Makita Cutter won't stop, this could indicate an electric or electronic malfunction. Remove the battery cartridge and ask your local authorized service center for repair.
Why does the wheel rotation not accelerate properly on my Makita DCE090 Cutter?
If the wheel rotation of your Makita Cutter does not accelerate properly, even after running the tool without load for 20 seconds, it could be due to a few reasons. First, ensure the battery is installed correctly as described in the manual. If the battery power is dropping, recharge the battery cartridge; if recharging isn't effective, replace it. The V-belt might also be slipping, requiring replacement with a new one. If these steps don't resolve the issue, the drive system may not be functioning correctly, and you should seek repair from an authorized service center.
Why does my Makita DCE090 Cutter have poor cutting performance?
Poor cutting performance on your Makita Cutter likely means it is time to replace the wheel with a new one.
What to do if water leaks from the inlet of my Makita DCE090 Cutter?
If water is leaking from the inlet of your Makita Cutter, specifically from the O-ring part, ask your local authorized service center for repair.
Why does the motor not run on my Makita Cutter?
If your Makita Cutter's motor doesn't run, it could be due to a few reasons. First, make sure that two battery cartridges are correctly installed, as the tool will not function with only one. If the battery is the issue (under voltage), try recharging it. If recharging doesn't work, replace the battery cartridge. If the problem persists, it is recommended to ask your local authorized service center for repair.
What to do if wheel rotation is not working properly on my Makita Cutter?
To Next Page
General