Makita DCL281F - Page 7

7 ENGLISH
Remove accumulated dust from the inside of capsule
andhighperformancelter.
1
2
►1. Capsule 2.Highperformancelter
Twisthighperformancelterindirectionofarrowto
unfasten securing lip from cleaner unit and then pull off
thelter.
1
►1. Securing lip
NOTE:Whenusingtheprelter,alsofollowthepro-
cedure above.
Cleanoutthenedustandlightlytaptodislodgedust
fromhighperformancelter.
Reassembly
Connecthighperformancelter.Atthistime,makesure
totwisthighperformanceltersothatsecuringlipis
rmlylockedintothecleanerunit.
1
►1.Highperformancelter
1
►1. Securing lip
NOTICE: Always be sure to check that high perfor-
mancelterisloadedcorrectlypriortousingcleaner.
If they are not loaded correctly, dust will get into the
motor housing, and cause motor failure.
If the problem as described later occurs, high per-
formancelterisnotloadedcorrectly.Reloadthem
correctly to rectify problem.
Attach the capsule. Align the mark on capsule with the
markonthehandleandthenrmlytwistcapsuleinthe
direction of arrow until it is secured.
3
2
1
►1. Mark 2. Handle 3. Capsule
NOTE:
Always remove dust ahead of time, as suction
power will be reduced if there is too much dust in cleaner.
Problem Examples
Thesecuringlipofhighperformancelterisnotrmly
locked into groove of cleaner housing.
2
1
►1. Securing lip 2. Groove of cleaner housing