Need help?Do you have a question about the Makita Dolmar DCS460 and is the answer not in the manual?
Correct method for installing the clutch flyweights.
Procedure for installing the clutch assembly.
Instructions for dismantling the starter mechanism.
Instructions for reassembling the starter, including spring and cable.
Steps for safely removing the engine flywheel.
Procedure for removing the ignition armature and its wiring.
Procedure for installing the ignition armature and setting the correct gap.
Steps to remove the carburetor, including fuel line and Bowden cable.
Procedure for removing the intake manifold and associated parts.
Steps to detach the carburetor bottom and flange.
Instructions for setting carburetor idle and high-speed screws.
Steps for disassembling the fuel tank and related parts.
Procedure for vacuum testing the fuel tank air valve.
Procedure for pressure testing the cylinder and piston for leaks.
Procedure for vacuum testing the crankcase and radial ring.
Steps for safely removing the cylinder and piston.
Procedure for reassembling the cylinder and piston with a new gasket.
Steps for assembling the crankcase halves and bearings.
Methods for testing electrical current in the handle heating system.
Measuring the electrical resistance of the heating elements in the handles.
Table listing torque specifications for various fasteners.
To Next Page
General
