9 ENGLISH
Optional accessory
WARNING: Do not install application tool
Installing application tool upside down
CAUTION: Clean up dust and perform lubri-
time to time.
moving part of the lock lever and hinder its smooth
movement.
CAUTION:
The lock
Fig.6
NOTICE:
NOTICE:
opens.
1.
Fig.7: 1. Lock lever 2.
2.
Fig.8: 1. 2. 3. Tool
4.
3. Return the lock lever to its original position.
held in place.
Fig.9: 1. Lock lever
To remove the application tool, follow the installation
procedures in reverse.
CAUTION:
-
Using sanding application tool
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
-
paper.
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
Fig.10: 1. Sanding paper
OPERATION
WARNING:
CAUTION:
tool.
CAUTION: -
NOTICE:
In this case, once isolate the application tool from
the workpiece, then the speed of the oscillation goes
NOTICE:
NOTICE:
-
-
Fig.11
tool movement does not slow down.
NOTE: Before cutting operation, it is recommended to
NOTE:
operation.
NOTE: The round saw is recommended for cutting
long straight line.
Sanding
NOTICE: Do not reuse a sanding paper used for
NOTICE:
Fig.12
NOTE: Before the operation, it is recommended to
test material sample as trial.
NOTE: It is recommended not to change the grid of
surface of the workpiece. Changing the grid of the
To Next Page
Loading...
