Makita DTW701RTJ User Manual

7 ENGLISH
Switch action
1
►1. Switch trigger
CAUTION: Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
Tostartthetool,simplypulltheswitchtrigger.Tool
speedisincreasedbyincreasingpressureontheswitch
trigger. Release the switch trigger to stop.
NOTE:Thetoolautomaticallystopswhenyoukeep
pulling the switch trigger for 6 minutes.
NOTE: When full speed mode is turned on, the rota-
tionspeedbecomesfastestevenifyoudonotpullthe
switchtriggerfully.
For detail information, refer to the section of full speed
mode.
Lighting up the front lamp
CAUTION: Do not look in the light or see the
source of light directly.
1
►1. Lamp
1
►1. Button
To turn on the lamp status, press the button for one second. To
turno󰀨thelampstatus,pressthebutton
for one second again.
With the lamp status ON, pull the switch trigger to turn on
thelamp.Toturno󰀨,releaseit.Thelampgoesoutapproxi-
mately10secondsafterreleasingtheswitchtrigger.
With the lamp status OFF, the lamp does not turn on
even if pulling the trigger.
NOTE: Toconrmthelampstatus,pullthetrigger.Whenthe
lamplightsupbypullingtheswitchtrigger,thelampstatusis
ON. When the lamp does not come on, the lamp status is OFF.
NOTE:Whenthetoolisoverheated,thelightashes
foroneminute,andthentheLEDdisplaygoeso󰀨.In
this case, cool down the tool before operating again.
NOTE:Useadryclothtowipethedirto󰀨thelensof
the lamp. Be careful not to scratch the lens of lamp, or
itmaylowertheillumination.
NOTE: While pulling the switch trigger, the lamp
status cannot be changed.
NOTE:Forapproximately10secondsafterreleasing
the switch trigger, the lamp status can be changed.
Reversing switch action
1
A
B
►1. Reversing switch lever
CAUTION: Always check the direction of
rotation before operation.
CAUTION: Use the reversing switch only after
the tool comes to a complete stop. Changing the direc-
tionofrotationbeforethetoolstopsmaydamagethetool.
CAUTION: When not operating the tool, always
set the reversing switch lever to the neutral position.

Makita DTW701RTJ Specifications

General

Brand	Makita
Model	DTW701RTJ
Category	Power Tool
Language	English