What to do if the chain of my Makita DUC256C does not stop when the chain brake is activated?
If the chain does not stop on your Makita Chainsaw even when the chain brake is activated, stop the machine immediately! The brake band is likely worn down and requires repair by an authorized service center.
Why is there abnormal vibration in my Makita DUC256C?
If you experience abnormal vibration with your Makita Chainsaw, immediately stop the machine. This could be due to a loose guide bar or saw chain, requiring you to adjust the tension. Alternatively, it could indicate a tool malfunction, in which case you should seek repair from an authorized service center.
Why my Makita Chainsaw does not start?
If your Makita Chainsaw doesn't start, it might be due to several reasons. First, ensure a charged battery cartridge is correctly installed. If the battery is low, recharge it or replace it if necessary. Also, check if the main power switch is turned off, as the chainsaw automatically shuts down after inactivity. Turn the main power switch on again to resolve this.
What does it mean when the main power lamp is blinking green on my Makita Chainsaw?
If your Makita Chainsaw's main power lamp is blinking green, it means the switch trigger is being pulled under an inoperable condition. Ensure the main power switch is turned on and the chain brake is released before pulling the switch trigger.
Why my Makita DUC256C does not reach maximum RPM?
If your Makita Chainsaw does not reach maximum RPM, the battery cartridge may be improperly installed; ensure it is correctly installed as described in the manual. Another cause could be dropping battery power, requiring you to recharge or replace the battery cartridge. If these steps do not solve the issue, the drive system may not be working correctly, and you should seek repair from an authorized service center.
Why does the motor of my Makita DUC256C Chainsaw stop after a little use?
If your Makita Chainsaw motor stops running after a short period, the battery charge level is likely low. Recharge the battery cartridges, and if recharging doesn't help, consider replacing the battery cartridge.
What to do if the saw chain does not run on my Makita Cordless Saw?
The saw chain might not run because the chain brake is activated. To resolve this, release the chain brake.
How to troubleshoot a Makita Cordless Saw that does not start?
If your Makita Cordless Saw doesn't start, several factors could be at play. First, ensure a charged battery cartridge is correctly installed. If the battery is low, recharge it or replace it if recharging doesn't help. Also, check if the main power switch is off, as the saw automatically shuts down after inactivity. If so, turn the main power switch on again.
What to do if Makita DUC256C Chainsaw has abnormal vibration?
If your Makita Chainsaw is vibrating abnormally, immediately stop the machine. This could be due to a loose guide bar or saw chain, so adjust the tension.
Why does my Makita DUC256C motor stop running quickly?
If the motor of your Makita Chainsaw stops running after a short time, it's likely that the battery's charge level is low. Try recharging the battery cartridges. If recharging doesn't solve the issue, consider replacing the battery cartridge.
To Next Page
General
