J
Javier BaileySep 6, 2025
What to do if Makita DUC400Z saw chain does not run?
- KKatherine BarberSep 7, 2025
If the saw chain on your Makita Chainsaw isn't running, it's possible that the chain brake is activated. Try releasing the chain brake.
To Next PageTo Next PageWhat to do if Makita DUC400Z saw chain does not run?
If the saw chain on your Makita Chainsaw isn't running, it's possible that the chain brake is activated. Try releasing the chain brake.
Why is the main power lamp blinking on my Makita Chainsaw?
The main power lamp on your Makita Chainsaw may be blinking because the switch trigger is pulled under an unoperable condition. Ensure the main power switch is on and the chain brake is released before pulling the switch trigger.
Why does my Makita DUC400Z motor stop running quickly?
If the motor of your Makita Chainsaw stops running after only a short period of use, the battery's charge level is likely low. Recharge the battery cartridges, and if recharging isn't effective, consider replacing the battery cartridge.
How to fix a Makita Chainsaw that does not reach maximum RPM?
If your Makita Chainsaw isn't reaching its maximum RPM, it could be due to a few reasons. First, ensure that the battery cartridge is installed correctly. If the battery power is dropping, try recharging the battery cartridges or replacing them if recharging is not effective.
What to do if the Makita DUC400Z Chainsaw chain does not run?
If the saw chain on your Makita Chainsaw isn't running, the chain brake might be activated. Try releasing the chain brake.
Why does my Makita DUC400Z not reach maximum RPM?
If your Makita Chainsaw does not reach maximum RPM, it could be due to a few reasons. Ensure the battery cartridges are installed correctly as described in the manual. Also, check if the battery power is dropping and recharge the battery cartridges or replace them if recharging is ineffective.
General| Type | Cordless Chainsaw |
|---|---|
| Power Source | Battery |
| Voltage | 36V |
| Battery Type | Lithium-ion |
| Chain Pitch | 3/8" |
| Oil Tank Capacity | 0.2 L |
| Chain Speed | 20 m/sec |
| Chain Gauge | 1.3 mm |
