To Next PageTo Next PageHow to remove stuck shear blades from a branch on a Makita Pole Saw?
If the shear blades of your Makita Pole Saw get stuck on a branch, it's likely because the branch is too thick. Release the switch trigger, then press the I/O switch to the "O" position. After that, gently and slowly pull the blades straight out from the branch.
How to remove stuck shear blades from branch on Makita DUP361 Power Tool?
If the shear blades of your Makita Power Tool are stuck on a branch, it's likely because the branch is too thick. Release the switch trigger, press the I/O switch to the 'O' position, and then gently pull the blades straight out from the branch.
What to do if Makita Power Tool shear blade does not move?
If the shear blade of your Makita Power Tool doesn't move, even when you pull the switch trigger, there are several potential causes. First, the battery might be low, so try charging it. Ensure the I/O switch is in the "I" position. If the shears are locked, unlock them by following the steps described in "Switch action". Also, check the connection cord to ensure it is not loose. If the I/O switch was in the “on” position when you inserted the battery, turn it off and on again. If none of these steps work, the switch trigger may be defective, and you should stop using the tool and seek repair at an authorized service center.
Why is the cut not smooth with my Makita Power Tool?
If the cut isn't smooth with your Makita Power Tool, it might be because the shear blades are dull or worn out. Try sharpening the shear blades or adjusting the blade clearance. If that doesn't help, you may need to replace the shear blades.
What to do if Makita DUP361 Power Tool shear blades are stuck on the branch?
If the shear blades of your Makita Power Tool get stuck on a branch, it's likely because the branch is too thick. Release the switch trigger and press the I/O switch to the "O" position. Then, gently pull the blades straight out from the branch.
Why is the switch trigger locked on my Makita DUP361?
If the switch trigger on your Makita Power Tool is locked and cannot be pulled, it may be because the shear blades were opened forcibly. Try switching the tool off and then on using the I/O switch. When switching on, the upper shear blade should close slightly.
Why is the cut not smooth with my Makita Pole Saw?
A rough cut with your Makita Pole Saw can occur if the shear blades are dull or worn out. Try sharpening the blades or adjusting their clearance. If the blades are worn out, consider replacing them.
What to do if the switch trigger is locked on my Makita Pole Saw?
If the switch trigger of your Makita Pole Saw is locked, it might be because the shear blades were opened forcibly. Try switching the I/O switch off and then on. When switching on, the upper shear blade should close slightly.
What to do if the switch trigger is locked on my Makita DUP361?
If the switch trigger of your Makita Power Tool is locked and cannot be pulled, it's likely because the shear blades were opened forcibly. To resolve this, switch the tool off and then on using the I/O switch. Note that the upper shear blade should close slightly when switching on.
How to unlock the switch trigger on my Makita DUP361 Power Tool?
If the switch trigger on your Makita Power Tool is locked and cannot be pulled, it may be because the shear blades were opened forcibly. Try switching the tool off and on using the I/O switch. When switching on, the upper shear blade should close slightly.
General| Battery Type | Lithium-ion |
|---|---|
| Cutting Width | 82 mm |
| Battery Voltage | 36 V |
| Blade Width | 82 mm |
| Type | Planer |
