Makita DUP362Z User Manual (English)

Questions and Answers:

E
egrayAug 7, 2025
What to do if Makita DUP362Z shear blade does not move?
- J
  Justin Lowery MDAug 7, 2025
  If the shear blade of your Makita Power Tool doesn't move, even when you pull the switch trigger, there are several potential causes. First, the battery might be low, so try charging it. Ensure the I/O switch is in the "I" position. If the shears are locked, unlock them by following the steps described in "Switch action". Also, check the connection cord to ensure it is not loose. If the I/O switch was in the “on” position when you inserted the battery, turn it off and on again. If none of these steps work, the switch trigger may be defective, and you should stop using the tool and seek repair at an authorized service center.
M
marywintersAug 11, 2025
Why is the cut not smooth with my Makita DUP362Z Power Tool?
- R
  rebecca76Aug 11, 2025
  If the cut isn't smooth with your Makita Power Tool, it might be because the shear blades are dull or worn out. Try sharpening the shear blades or adjusting the blade clearance. If that doesn't help, you may need to replace the shear blades.
D
Diana Moore DDSAug 15, 2025
What to do if Makita DUP362Z Power Tool shear blades are stuck on the branch?
- C
  Christian SalazarAug 15, 2025
  If the shear blades of your Makita Power Tool get stuck on a branch, it's likely because the branch is too thick. Release the switch trigger and press the I/O switch to the "O" position. Then, gently pull the blades straight out from the branch.
R
Ricardo Lucas Jr.Aug 20, 2025
Why is the switch trigger locked on my Makita DUP362Z?
- K
  Keith DavidsonAug 20, 2025
  If the switch trigger on your Makita Power Tool is locked and cannot be pulled, it may be because the shear blades were opened forcibly. Try switching the tool off and then on using the I/O switch. When switching on, the upper shear blade should close slightly.