14 ENGLISH
Green Red
-
Green Red
•
-
and ask your local authorized service center for repair.
ASSEMBLY
CAUTION: Always be sure that the tool is
before carrying out any work on the tool.
Installing the battery holder into the
backpack
Fig.9: 1. Clamp 2. Battery holder 3. Strap
1.
2.
Installing the holster
Fig.10: 1. Holster 2. Strap
Adjusting the harness
1.
Fig.11: 1.
2.
Fig.12
3.
Fig.13: 1.
CAUTION: In case of emergency, quickly
open the lower buckle and upper buckle, loosen
shoulder straps, and set down the backpack.
Installing the connection cord
CAUTION: Always make sure that the switch
box's I/O switch is on the "O" side before attach-
ing the connection cord.
CAUTION: Do not operate the tool if the con-
nection cord is damaged.
NOTICE:
connection cord away from heat, oil, or sharp edges.
shears as follows:
1. First, align the triangular marks of the male plug
of the connection cord with the triangular mark of the
Then, align the marking on the coupling with the trian-
glar marks, and push in and turn the coupling to tighten.
Fig.14:
1. Triangular mark 2. Connection cord 3. Switch
4. Marking on coupling 5. Coupling
NOTICE: Turn the coupling and align the marking
2.
Fig.15
3. Push the connection cord into the loop of the cord
holder.
Fig.16
The cord holder prevents the connection cord from dan-
Fig.17
Fig.18
NOTICE: Do not hang anything other than the
connection code on the cord holder. Otherwise the
NOTICE: Do not force the cord holder opening.
the code holder.
4. -
Fig.19: 1.
5. First, align the triangular marks of the female
socket of the connection cord with the triangular mark
of the male connector of the shears. Push in the socket
of the connection cord to the connector of the shears.
Then, align the marking on the coupling with the trian-
glar marks, and push in and turn the coupling to tighten.
Fig.20:
1. Triangular mark 2. Connection cord
3. Shears 4. Marking on coupling 5. Coupling
NOTICE: Turn the coupling and align the marking
To Next Page
Loading...
Need help?
General
