12 ENGLISH
N Mark
The N Mark is a trademark or registered trademark of
NFC Formula, Inc. in USA and other countries in the
world.
(This tool is equipped with an NFC receiver only for
centers.)
PARTS DESCRIPTION
Fig.1
1 Harness * 2 Back pack 3 4 Pilot lamp (red)
5 Pilot lamp (green) 6 I/O switch 7 Holster 8 Cord holder
9 Connection cord 10 Shears 11 Switch trigger - -
FUNCTIONAL
DESCRIPTION
CAUTION: Always be sure that the tool is
before adjusting or checking function on the tool.
Removing or installing battery
cartridge
CAUTION:
installing or removing of the battery cartridge.
CAUTION: Hold the tool and the battery car-
cartridge.
Fig.2: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
CAUTION: Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
you or someone around you.
CAUTION: Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
NOTE:
cartridge.
Tool / battery protection system
is placed under one of the following conditions. In some
Overload protection
When the tool is operated in a manner that causes it to
stops without any indication. In this situation, turn the
Overheat protection
When the tool is overheated, the tool stops automati-
tool on again.
Overdischarge protection
To Next Page
Loading...
Need help?
General
