To Next PageTo Next PageHow to remove stuck shear blades from a branch on a Makita Pole Saw?
If the shear blades of your Makita Pole Saw get stuck on a branch, it's likely because the branch is too thick. Release the switch trigger, then press the I/O switch to the "O" position. After that, gently and slowly pull the blades straight out from the branch.
How to remove stuck shear blades from branch on Makita DUP362PT2 Power Tool?
If the shear blades of your Makita Power Tool are stuck on a branch, it's likely because the branch is too thick. Release the switch trigger, press the I/O switch to the 'O' position, and then gently pull the blades straight out from the branch.
General| Voltage | 18 V |
|---|---|
| Battery Type | Lithium-ion |
| Net Weight | 3.7 kg |
| Planing Width | 82 mm |
| Planing Depth | 2 mm |
| No Load Speed | 15, 000 rpm |
