Makita DUP362PT2 User Manual

11 ENGLISH
N Mark
The N Mark is a trademark or registered trademark of NFC
Formula, Inc. in USA and other countries in the world.
(ThistoolisequippedwithanNFCreceiveronlyfor
aservicepurposeusedbyauthorized/factoryservice
centers.)
PARTS DESCRIPTION
►Fig.1
1 Harness * 2 Back pack 3 Switchbox 4 Pilot lamp (red)
5 Pilot lamp (green) 6 I/O switch 7 Holster 8 Cord holder
9 Connection cord 10 Shears 11 Switch trigger - -
* The shape may differ depending on the tool variation.
FUNCTIONAL
DESCRIPTION
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Removing or installing battery
cartridge
CAUTION: Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION: Hold the tool and the battery car-
tridge rmly when installing or removing battery
cartridge.Failuretoholdthetoolandthebattery
cartridgermlymaycausethemtoslipoffyourhands
andresultindamagetothetoolandbatterycartridge
andapersonalinjury.
►Fig.2: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder
Toremovethebatterycartridge,slideitfromthetool
whileslidingthebuttononthefrontofthecartridge.
Toinstallthebatterycartridge,alignthetongueonthe
batterycartridgewiththegrooveinthehousingandslip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
uppersideofthebutton,itisnotlockedcompletely.
CAUTION: Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
itmayaccidentallyfalloutofthetool,causinginjuryto
you or someone around you.
CAUTION: Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
notbeinginsertedcorrectly.
NOTE:Thetooldoesnotworkwithonlyonebattery
cartridge.
Tool / battery protection system
Thetoolisequippedwithatool/batteryprotection
system. This system automatically cuts off power to
themotortoextendtoolandbatterylife.Thetoolwill
automaticallystopduringoperationifthetoolorbattery
is placed under one of the following conditions. In some
conditions,thelampsontheswitchboxlightsup.
Overload protection
When the tool is operated in a manner that causes it to
drawanabnormallyhighcurrent,thetoolautomatically
stops without any indication. In this situation, turn the
tool off and stop the application that caused the tool to
becomeoverloaded.Thenturnthetoolontorestart.
Overheat protection
When the tool is overheated, the tool stops automati-
cally,andthegreenlampontheswitchboxblinks.In
thissituation,letthetoolcooldownbeforeturningthe
tool on again.
Overdischarge protection
Whenthebatterycapacitybecomeslow,thetoolstops
automatically.Andtheredlampontheswitchboxlights
uporblinks.Iftheproductdoesnotoperateevenwhen
theswitchesareoperated,removethebatteriesfrom
thebatteryholderandchargethebatteries.

Makita DUP362PT2 Specifications

General

Brand	Makita
Model	DUP362PT2
Category	Power Tool
Language	English