Makita EA4300F - Crankcase; Crankshaft

___
Reparaturanleitung PS-4600 / PS-5000 27
Repair manual DCS3500 / DCS3501 / DCS4300 / DCS4301 / EA3500F / EA3501F / EA4300F / EA4301F / MEA3500L / MEA3500M / MEA4300G / MEA4300L
Crankcase sides MS and CS are attached with
six screws 1.
Two pins 2 ensure proper fitting.
When assembling the ball bearings, note the
following:
• Press one ball bearing onto the clutch side
of the crankshaft. Press the bearing onto the
shaft using an assembly sleeve, pressing
only on the inner bearing ring. Place a
wedge between the crank webs.
• Heat the clutch side of the crankcase to
150-160
°
C using a hot-air blower or in an
oven. Evenly apply Loctite 620 to the outer
ring of the bearing (on the crankshaft), and
insert into the heated housing without further
pressure.
Note: Before applying the Loctite 620,
degrease both bearings.
• Heat the magneto side of the crankcase to
150-160
°
C using a hot-air blower or in an
oven. Evenly apply Loctite 620 to the
bearings, and insert into the heated housing
without further pressure.
• Reattach the crankcase sides. Place a
wedge between the crank webs when
pressing.
Always use a
new gasket. After bolting the
crankcase sides together, cut off the flash 3.
DOLMAR offers complete crankcases with
preinstalled bearings as replacement parts.
3
4
5
MS
KS
1
2
12
CRANKCASE / CRANKSHAFT