Need help?Do you have a question about the Makita LB1200F and is the answer not in the manual?
General| Purpose | - |
|---|---|
| Cutting speed | 13.3 m/s |
| Product color | Black, Blue |
| Beveling table | Yes |
| Number of speeds | 2 |
| Table bevel angle | -2 - 45 ° |
| Idle speed (max) | - RPM |
| Blade length | 2240 mm |
| Input power | 900 W |
| Power source | AC |
| AC input voltage | 230 V |
Weight and Dimensions| Depth | 615 mm |
|---|---|
| Width | 775 mm |
| Height | 1600 mm |
| Weight | 81200 g |
| Table depth | 440 mm |
| Table width | 560 mm |
Displays symbols used for the tool to ensure understanding of their meaning.
Specifies that the tool is intended for cutting in wood.
Details power connection requirements and insulation standards.
Lists essential safety precautions for operating electric tools to reduce risks.
Provides specific safety rules and warnings tailored for the band saw tool.
Instructions on how to secure the band saw stand to prevent tipping or sliding.
Guide on loading the dust box into the machine from underneath the table.
Steps for fastening the guide rail to the table using thumb screws and washers.
Explains how to operate the ON/OFF switch and the switch cover.
Instructions on using the switch to turn the light on or off.
Describes the function and usage of the push stick for safety.
Details the insertion and adjustment of the miter gauge for angled cuts.
Instructions for installing and positioning the rip fence on either side of the blade.
Steps to reverse the rip fence for different cutting configurations.
Procedure for clamping the rip fence securely against the table edge.
Instructions for adjusting the cutting speed by changing the belt position on the pulleys.
Details on adjusting the belt tension using the setting knob for optimal performance.
Guide on how to properly tension the band saw blade using the adjustment knob and scale.
Procedure for correcting blade tracking by adjusting the tilt of the upper band saw wheel.
Explains the function of the quick release lever for reducing saw blade tension.
Instructions for adjusting the height of the upper blade guide to accommodate workpiece size.
Details on aligning the lower blade guide, including thrust and guide bearings.
Steps to adjust the thrust bearing for proper blade support from the rear.
Procedure for adjusting the guide bearings for lateral support of the blade.
Instructions for setting the saw table at a right angle to the band saw blade.
Step-by-step guide for safely removing and installing a new band saw blade.
Essential safety precautions to observe when operating the saw to minimize injury risk.
Guidelines and warnings for performing cutting operations, including kickback prevention.
Instructions for tilting the saw table for bevel cuts, including caution for placement.
Information on connecting a dust collector or vacuum cleaner for dust extraction.
Guidelines for cleaning sawdust and chips from the blade guard and moving parts.
Recommendations for oiling or greasing moving parts to ensure optimal running condition.
To Next Page
