3. Compound cutting
Compound cutting can be performed at angles shown in the table below.
Bevel
angle
1
Miter
angle
45O
I
Left
and
right
0'
-
45"
When performing the compound cutting, refer to "Miter cutting" and "Bevel cut"
explanations.
4.
Cutting crown and cove moldings
*Crown and cove molding can be cut on
a
compound cut with the moldings laid flat on
the turn base.
*There are two common types of crown moldings and one type of cove molding; 52/38'
wall angle crown molding, 45" wall angle crown molding and 45" wall angle cove mold-
ing. See illustrations below.
Ceiling Ceiling Ceiling
- -
-
- -
-
2
3
2
crown molding crown molding cove molding
*There are crown and cove molding joints to fit "Inside"
90"
corners
(0
and
@
in Fig.
A)
and "Outside"
90"
corners
(@
and
@
in Fig.
A).
-
-
Inside corner Outside corner
Fig.
(A)
Inside corner
16
To Next Page
Loading...
