What to do if there is no chain lubrication in Makita UC 4001A Chainsaw?
If your Makita Chainsaw isn't lubricating the chain, the oil tank might be empty, or the oil guide groove could be dirty. Check these components.
What to do if run-out brake fails in Makita UC 4001A Chainsaw?
If the run-out brake is not working on your Makita Chainsaw, the carbon brushes may be worn down. Replace the carbon brushes.
What to do if chain brake fails in Makita Chainsaw?
If the chain brake on your Makita Chainsaw is malfunctioning, it may be due to a worn-down brake band. Replace the brake band to resolve this issue.
General| Power Source | Electric |
|---|---|
| Motor Power/Power Input | 1800 W |
| Voltage | 230 V |
| Bar Length | 40 cm (16") |
| Weight | 4.7 kg |
| Chain Pitch | 3/8" |
| Chain Gauge | 1.3 mm |
| Oil Tank Capacity | 0.2 L |
General safety advice and user responsibilities for operating the chain saw safely.
Essential gear like helmets, eye/ear protection, gloves, and boots for user safety.
Steps and precautions for safely starting and using the electric chain saw.
Guidelines for safe handling, cutting techniques, and environmental awareness during operation.
Step-by-step instructions for assembling the guide bar and saw chain onto the saw.
Procedure for properly tensioning the saw chain using the adjustment screw.
How to verify the correct tension of the saw chain for safe operation.
Explanation of the inertial and manual chain brake function and engagement.
Description of the run-out brake that stops the chain when the motor is switched off.
Importance of regular inspection and maintenance of the brake systems by a service center.
Instructions for safely refilling the chain oil tank.
Guidance on ensuring adequate chain lubrication for optimal performance and longevity.
Test procedure to ensure the chain brake is functioning correctly.
Instructions and techniques for sharpening the saw chain for optimal cutting.
Maintenance steps for the guide bar and sprocket nose.
Guide on how to replace the saw chain, including sprocket inspection.
Procedure for checking and replacing worn carbon brushes.
Common problems, their causes, and solutions for the electric chain saw.
Regular cleaning and checks for the chain saw, chain, and guide bar.
Pre-operation checks including chain, lubrication, brakes, and power switch.
Post-operation cleaning and checks of the chain carrier and guide bar.
Guidelines for safely storing the chain saw and its components.
Recommendation to use MAKITA service centers for complex maintenance and repairs.
Importance of using original MAKITA spare parts for safety and reliability.
To Next Page
