11
1
010892
Take out the undercover from the tool.
1
010893
Loosen two screws with a coin and similars and remove
the shear blades.
NOTE:
• Do not remove the screws. Without removing the
screws loosened, shear blades can be removed.
1
2
010894
Remove the crank from the shear blades.
NOTE:
• The crank may remain in the tool.
Installing the hedge shear blades
12
3
010904
Prepare the crank, the undercover and new shear
blades.
1
2
010905
Adjust the three detent pin position so that these three
pins are aligned with the basic alignment line on the tool
housing.
1
2
3
4
010906
Fit the crank with its recessed part facing downward onto
the detent pins. At this time, apply a small amount of
grease to the periphery of the crank using grease that the
1. Crank
2. Apply grease.
3. Pins
4. Recessed part of crank
1. Basic alignment line on the tool housing
2. Pins
1. Crank
2. Undercover
3. Shear blades
1. Crank
2. Shear blades
1. Screws
1. Undercover
To Next Page
Loading...
Need help?
General
