Makita VC3510 - Using with Power Tools; Maintenance; Changing the Dust Bag

- 15 -
Cod.
83 133B8K *
EN
4 .... TO USE A POWER TOOL WITH THE VACUUM CLEANER:
CAUTION: The lter cartridge should always be attached (Fig. “C1”).
Remove the foam lter if installed (Fig. “C4”).
- Alwayskeeptheltersystemingoodworkingordertoensureefcientoperation.
- Werecommendtherepetitivecleaningofthelterelement.
- Insertthesleeveoftheexiblehose(partno.01321B0N)intheairinletconnector(r)(g.
“C5”)and the adapter (u) in the dust conveyer of the electric power tool(g.“C6”).
- Plug in the power tool, then the vacuumasdescribedinpoint“A5”(g.“C7”-“C8”).
- Withthecableclampcod.50318BHN,xthecableoftheelectricpowertooltotheexible
hose(g.“C9”).
- Turn on the appliance as described in point “A3”.
D - MAINTENANCE
VERY
IMPORTANT: Always unplug the appliance from the
power supply before cleaning or servicing
the lter system in any way.
1 .... CHANGING THE DUST BAG
(pack code 83 133B8K *)
CAUTION: The paper bag must never be re-used but only be replaced.
- Removetheplasticange(1)fromtheairinletconnector(2)(g.“D1”).
- Take out the full bag(g.“D2”).
- Closetheplasticangewiththecapprovided(g.“D3”).
* Pack code