EasyManuals Logo
Home>Makita>Lawn Mower>XML02

Makita XML02 Manual

Makita XML02
5 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
1. Mowing height adjusting lever
NOTE: The mowing height figures should be used just as a guideline. Depending on the conditions of the lawn or
the ground, the actual lawn height may become slightly different from the set height.
NOTE: Try a test mowing of grass in a less conspicuous place to get your desired height.
1. Grass level indicator
Grass level indicator shows the volume of mowed grass.
• When the grass basket is not full, the indicator floats during mowing.
• When the grass basket is full, the indicator does not float during mowing. In this case, stop mowing immediately
and empty the basket. After emptying the basket, clean it so that its meshwork vents the air.
NOTE: This indicator is a rough guide. Depending on the conditions of inside of the basket, this indicator may not
work properly.
1. Remove the lock key.
2. Lift the rear guard of the mower body.
3. Hook the grass basket on the groove of the mower body as shown in the figure
1. Hook 2. Groove 3. Grass basket
Before mowing, clear away sticks and stones from mowing area. Furthermore, clear away any weeds from
mowing area in advance. Always wear the safety goggles or safety glasses with side shields when
operating the mower.
Firmly hold the lawn mower handle with both hands when mowing. The outside edges of the front wheels is
the guideline for mowing width. Using the two front wheel outside edges as a guideline, mow in strips,
overlapping by one half to one third the previous strip, to mow the lawn evenly. Periodically check the grass
basket for mowed grass. Empty the grass before it becomes full. Before every periodical check, be sure to stop
the mower then remove the lock key and the battery cartridge.
NOTE: Using the mower with the grass basket full prevents smooth blade rotation and places an extra load on the motor, which may cause breakdown.
MOWING TALL GRASS. Do not try to cut long grass all in one go. Instead, mow the lawn in some steps. Leave a day or two between mows until the lawn becomes evenly
short.
NOTE: Mowing long grass to a short length all in one go may cause the grass to die. The cut grass may also block up inside of the mower body.
CLEANING Clean the mower using only a wet cloth. Do not spray or pour water on the mower when cleaning. Put the mower on its side and clean grass clippings
accumulated on the underside of mower deck.

Other manuals for Makita XML02

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Makita XML02 and is the answer not in the manual?

Makita XML02 Specifications

General IconGeneral
BrandMakita
ModelXML02
CategoryLawn Mower
LanguageEnglish

Related product manuals