To Next PageTo Next Page
Need help?Do you have a question about the Makita XPH01 and is the answer not in the manual?
General| Model | XPH01 |
|---|---|
| Type | Cordless Hammer Drill |
| Voltage | 18V |
| Battery Type | Lithium-Ion |
| Max Torque | 480 in.lbs. |
| Chuck Size | 1/2" |
| Chuck Type | Keyless |
| Overall Length | 8-1/8" |
| Max. Capacity (Steel) | 1/2" |
| Max. Capacity (Wood) | 1-1/2" |
| Weight | 4.0 lbs. |
Keep work area clean, avoid explosive atmospheres, keep bystanders away.
Match plugs to outlets, avoid wet conditions, don't abuse cords, use outdoor/GFCI cords.
Stay alert, use PPE, prevent unintentional starting, don't overreach, dress properly.
Use correct tool, don't force, check switch, disconnect power for adjustments, store properly.
Maintain tools, keep cutting tools sharp, use in accordance with instructions.
Recharge with specified charger, use designated packs, avoid shorting, avoid high temps, don't incinerate.
Avoid contact with ejected liquid, flush with water if contact occurs, seek medical help for eye contact.
Read all instructions, don't disassemble, stop if operating time shortens, handle electrolyte carefully.
Avoid shorting terminals, avoid high temps, don't incinerate, don't drop/strike, don't use damaged battery, follow disposal regs.
Charge before discharge, stop and charge when power is low, don't overcharge, charge at room temp, cool hot batteries.
Ensure tool is off, insert until locked, check red indicator.
System cuts off power to extend life; tool stops under specific conditions.
Pull trigger to start/control speed, release to stop; lamp lights when trigger pulled.
Check direction before use, stop tool before changing direction, set to neutral; switch off to change speed.
Select mode (rotation, hammer, clutch) and adjust torque by aligning rings and graduations.
Open chuck counterclockwise, insert bit, tighten clockwise; install hook on housing with screw.
Accessory fits to tool foot, secure with screw; store bits in holder.
Insert battery fully until locked; hold tool firmly with two hands to control twisting action.
Select hammer mode, use carbide bit, position bit, pull trigger, don't force; clear clogged holes.
Optional accessory to clean dust from holes after drilling.
Select clutch mode, adjust torque, insert bit straight, start slowly, release when clutch engages.
Use pilot holes for wood, center punch for metal, use lubricant for metals (except iron/brass).
Replace when worn to limit mark, use identical brushes, remove rear cover, replace brushes and caps.
Reinstall rear cover, break in new brushes by running tool unloaded for 1 min.
Use recommended accessories only; ask service center for details.
One year warranty against defects; excludes normal wear, abuse, or unauthorized repairs.
Dust contains cancer/birth defect chemicals; reduce exposure with ventilation/PPE.
