To Next PageTo Next Page
Need help?Do you have a question about the Makita XPH06 and is the answer not in the manual?
General| Voltage | 18V |
|---|---|
| Battery Type | Lithium-Ion |
| Speed | 0 - 550 / 0 - 2, 000 RPM |
| Chuck Size | 1/2 inch |
| Weight | 5.1 lbs |
| Length | 8-1/8 inches |
| Type | Hammer Drill |
| Battery | BL1850B |
Keep work area clean, well-lit, and free from hazards.
Follow guidelines to prevent electric shock.
Ensure operator alertness and use protective equipment.
Wear ear protectors during impact drilling to prevent hearing loss.
Utilize auxiliary handles for enhanced control and safety.
Hold the tool by insulated surfaces to avoid electric shock.
Review all manual, charger, and battery instructions before use.
Never disassemble the battery cartridge to prevent injury or fire.
Cease operation immediately if operating time shortens due to overheating risks.
Recharge the battery before it's completely depleted to prolong its lifespan.
Do not recharge a fully charged battery as it reduces service life.
Charge the battery within the 10°C-40°C range for best performance.
Charge battery every six months for long-term storage.
Proper procedure for inserting and removing battery packs.
Explains the system that cuts power to extend battery life.
How the LED display shows the remaining battery charge level.
How to operate the LED lamp for illumination.
How to start, stop, and control speed using the switch trigger.
Changing the direction of tool rotation using the reversing lever.
How to select between high and low speed settings.
Choosing between drilling, hammer drilling, and screwdriving modes.
Setting the appropriate torque for driving screws.
Procedure for inserting and removing drill or driver bits.
How to attach the hook for temporary hanging.
General guidelines for holding and operating the tool.
Techniques for drilling into hard materials with hammering.
Steps for driving screws using the tool's clutch.
General guidance for drilling holes in various materials.
Specific tips for drilling in wood and metal.
Precautions and procedures for tool inspection and upkeep.
List of recommended accessories for the tool.
Details of the manufacturer's limited warranty terms and conditions.
