Page 12 of 13
8.4. Temperature sensor damage indication.
If the regulator etects damage to the temperature sensor, the letters ACU appears
on the display, and at the same time the audible alarm signal is activated. The operation
of the unit and the stirrer is interrupted until the failure is removed.
ATTENTION
Sensor damage indication also occurs if the range of temperatures measured by the
regulator is exceeded.
DESCRIPTION OF THE
PARAMETER
limitation of the lower value
for the control temperature
range
the possibility of setting the temperature from
-40
O
C to +120
O
C, every 1.0
O
C
limitation of the upper value
for the control temperature
range
the possibility of setting the temperature from
-40
O
C to +120
O
C, every 1.0
O
C
the possibility of setting the temperature:
• from 0.2
O
C to 10
O
C, every 0.2
O
C – for the
range from -10
O
C to +100
O
C and
• from 1.0
O
C to 10
O
C, every 1.0
O
C – for the
range of <-10
O
C and > + 100
O
C
minimum working time of the
unit
0 – off
1 – on: the possibility of setting the time from
1 min. to 60 min., every 1 min.
maximum working time of the
unit
0 – off
1 – on: the possibility of setting the time from
0,5 h to 9,5 h, every 0,5 h
minimum standstill time of
the unit (standby)
0 – off
1 – on: the possibility of setting the time from
1 min. to 60 min., every 1 min.
time after which the unit is
turned off after the flap of the
milk tank
is opened
0 – off
1 – on: the possibility of setting the time from 0,1
min. (6 s.) to 15 min., every 0,1 min. (6 s.)
0 – operation according to the times set in
the parameters E1 and E2, regardless of the
operation of the unit
1 – continuous operation while the unit is
running; when the unit is on standby, the stirrer
operates according to the times set in the